Guide shaft or guide rod for the center of the pull arm on early Polar 115 CE and 115 EL cutters, built before machine serial number 4731747. These early Polar 115 EL and 115 CE are the ones that use 2 shear bolts in the pull arm and use a roll pin to secure the bottom of the guide rode in place.
If your pull arm uses a set screw to mount the guide rod in place then see our part number PPEGS350.
The later 115 EMC 2 cutters (after about 1984) have a single center shear bolt and use our guide rod part number PPEGS353.
This 14mm diameter alignment rod fits up the middle of the pull arm to prevent it from flapping around and causing damage when the shear bolt breaks. It is made from centerless ground drill rod for maximum toughness. Overall length is approximately 15" long. (original Polar part number 207463 or 218649)
Our policy lasts 30 days. If 30 days have gone by since your purchase, unfortunately we can’t offer you a refund or exchange.
To complete your return, we require a receipt or proof of purchase.
Customized products and gift cards are exempt from being returned.
Heidelberg OEM Parts are subject to re Stocking fees.
Once your return is received and inspected, we will send you an email to notify you that we have received your returned item. We will also notify you of the approval or rejection of your refund.
If you are approved, then your refund will be processed, and a credit will automatically be applied to your credit card or original method of payment, within 30 days.
Late or missing refunds
- If you haven’t received a refund yet, first check your bank account again.
- Then contact your credit card company, it may take some time before your refund is officially posted.
- Next contact your bank. There is often some processing time before a refund is posted.
- If you’ve done all of this and you still have not received your refund yet, please contact us at